1 - Screw out cartomizer from the battery.
2 - Slowly pull out the silicone cap from ceramic cup using paper clip.
3 - Pour excessive liquid inside the tube.
4 - Without removing the clear tube, soak into clean water overnite. Just to make sure the 'wick'
clean enough from e-juice.
5 - Slowly blow from the mouth tip to remove out water inside the air hole, then wipe clean the
6 - Screw back into the battery then slowly remove the clear tube.
7 - Start the dry burn process untill the coil and wick become clean. (This procedure only can
be done by the manual battery)
8 - Screw out from battery and let for 2 minutes for the ceramic cup cooling down.
9 - Slowly put back the clear tube after clean it from the excessive water.
10- Refill with e liquid for 3/4 full then put back the silicone cap.
11- Push the silicone cap back into the ceramic cup by holding the bottom side of cartomizer.
Just to make sure the tubing not slip out.
12- Slowly blow out from the mouth tip, to make sure no liquid inside the air hole.
13- Wipe clean the connector then slowly screw back into battery.
Note: Always keep this type cartomizers in vertical way to avoid liquid from leak due to overwicking.