- Compatible with SSOCC (stainless steel organic cotton coil) and Mini RBA plus
- Temperature Control Mode
- 10 ml tank
- MicroUSB Charging
- LCD Display
- Delrin Drip Tip
- Output 7-60W
- Requires one 18650 hi drain battery (sold separately)
- 1 x NEBOX Unit
- 1 x SSOCC 0.15 SUB Ohm atomizer head
- 1 x SSOCC 0.5 Ohm atomizer head
- 1 x Mini RBA Deck Plus
- 2 x RBA Coils
- 1 x Japanese Cotton Sheet
- 1 x Manual
- 1 x Micro USB Cable
- 1 x Drip tip
1 x Cfiber 100w 3000mAh Mod
1 x USB Charging cable
Battery Capacity 3000mAh
Approx 2 - 3 Hour Charge Time
Carbon Fibre Body
Stainless Steel Hollowed Out Neck
0.1ohm - 0.6ohm (Automatically senses the resistance of your atomizer)
Micro-USB Charger (Charge on the go)
5 Click On/Off Safety
Approx Dimensions: 110mm x 22mm
For use with resistances in the range: 0.1 ohm-0.6 ohm
Kanger EVOD blisters are global most famous and the best deal in the market , good Quality , low Price and eGo standard in many configurations.
Longer battery life, More power, and more vapor! That's what everyone is looking for and EVOD Blister Kit delivers.
1* Kanger EVOD 900mah Battery
1* Ce4 Clearomizer
1* Rapid 420mAh USB charger
FREE Leather lanyard
Full battery capacity: 900mah/1000puffs
Battery life: 300 times recharging
Charging time: 2-3 hours
Battery Protection Function
*no tar*no tobacco*odour free
Easy operation, portable, simple assembling, power directly from battery.
Safe, clean, environment friendly, no passive smoke.
No harmful substances, healthy and green
- Copper mod with brass hybrid top cap.
- Hobo RDA included (copper).
- Also can use with Kayfun, with central plot post coming out from the 510 connector.
- Recessed 22mm top only for ø22.00mm atomizer.
- The recessed is ø22.05mm.
- Three vent holes for battery gaz security.
- No adjustable pin, the center positive post of the atomizer is in direct contact with the battery nipple.
- AW IMR 18350 or EFEST IMR 18350 with nipple recommended.
- The battery is directly adjusted when you screw the atomizer on the body with the brass hybrid kit provided.
- The switch is recessed spring, without locking system.
See product review HERE
Hobo RDA review and rebuild HERE
Authentic Joyetech eGrip OLED-CL 30W
Package content :
1 x eGrip mouthpiece
1 x eGrip Body
2 x eGo ONE CL Atomizer Head (1.0 ohm)
1 x eGrip CL base
8 x Seal Ring of CL base
1 x 1A Wall adapter
1 x USB cable
1 x Manual & Warranty Card
- eGrip OLED CL Kit doesn't come with e-liquids. You shall purchase e-liquids separately.
- There is CE mark on battery end.
- You can use eGo one atomizer head and eGo One CLR Atomizer Head for this device. 1.0 ohm is recommended for this device.
Note: To adjust the max output to 30W, please press the fire button 30 times in succession after turn it off.
The eGo ONE is charged through a Micro USB Port via a computer or a wall adapter with the USB cable. It can also work as a pass-through device for simultaneous vaping and charging. The battery must contain a small charge before it can be used in this way. If you're using the battery quicker than it can charge, the battery will shutoff. We suggest charging the battery for 10-15 minutes before using it.
ON/OFF battery switch:
Press the power button five times in rapid succession to turn on the eGo ONE. Once the eGo ONE is on, hold down the power button to activate the atomizer and vape. When the eGo ONE is not in use, press the power button five times in succession to power off the device. Always power off the eGo ONE when it is not being used, or when it is going to be stored in a pocket, bag or purse.
The eGo ONE has a built-in 1100mAh polymer Li-Ion rechargeable battery.
15 second cutoff:
If the activation button is held for 15 seconds or longer the device will stop firing until the button is released and pressed again.
Low voltage warning:
The indicator light will continue blinking when the battery capacity is lower than 3.3V and the device will power off automatically.
Short circuit protection:
Short circuit protection protects the device against shorted atomizers and will stop the unit from functioning in unsafe conditions.
Battery display function:
The light indicator will flash slowly or stay lit when battery level is high, and the light will flash with frequency if low.
Battery quantity Light condition
60% - 100% Stay lit
30% - 59% Slowly flashes
10% - 29% Moderately flashes
0 - 9% Flashes in frequency
The battery light flashes red when charging or connecting with USB, and goes out in 5 seconds when it is fully charged.
- 510 Threaded
- 2.5ml Capacity Tank
- Operating Voltage: 3.3 - 4.2 V
- Stainless steel construction
- Available in 1100 mAh or 2200 mAh
- Adjustable airflow control valve
- Low voltage protection
- Short circuit protection
- Minimum Resistance: 0.5 ohms
- Dimensions:4-1/4" x 3/4"D (Including Drip Tip)
- 1 x eGo ONE battery
- 1 x eGo ONE Atomizer Tube
- 2 x eGo ONE CL Atomizer Head (0.5/1.0ohm)
- 1 x eGo ONE Atomizer Base
- 1 x eGo ONE Mouthpiece (Metal)
- 1 x eGo ONE Mouthpiece (Glass)
- 1 x Micro USB Cable
- 1 x Manual and Warranty Card
- 1 x Wall Adapter(1A)